Zero Touch Provisioning is a process that enables you to remotely configure new Edge Threat Management NG Firewall or Micro Edge hardware appliances using ETM Dashboard. Zero Touch Provisioning reduces the complexity of deployment by eliminating the need to configure the appliance from the local network.
- Zero Touch Provisioning is supported on official Edge Threat Management hardware appliances. NG Firewall appliances must be running version 14.1 or higher. Zero Touch Provisioning is supported on all current versions of Micro Edge.
- Your Internet connection must support automatic IP assignment. Connections using PPPoE or requiring manual IP configuration cannot provision using Zero Touch Provisioning.
How it works
The process for Zero Touch Provisioning follows:
- Once you receive the appliance, mount the device and attach any physical components as described in the Setup Guide.
- Take note of the serial number located on the side or bottom of the device.
- Connect the ethernet cable from your Internet router or modem to the External port of your Edge Threat Management appliance.
- Connect the power and turn on the device.
- Wait a few minutes for the system to boot, then Adding Edge Threat Management appliances to ETM Dashboard using the serial number.
After you add the appliance, you can assign Configuration Templates or remotely access the administration interface. If you do not want to manage your appliance from ETM Dashboard, you can disconnect the appliance.Follow