You've just ordered your NG Firewall from us and want to know what else you may need or what you need to do once you receive your appliance.
What you'll need
- HDMI cable
IMPORTANT Do not use any adapters or KVM switches when connecting. This can cause issues.
- Ethernet cable(s)
If you purchased an NG Firewall appliance, the software will come pre-installed on your device so you don't need to worry about installation. If you are using your own hardware platform, then please refer to our installation guide which will also walk you through the Setup Wizard.
Each new installation of NG Firewall comes with a free 30-day trial so you can experiment with full functionality before you deploy it or make decisions around purchasing your license.
Power it on
Connect the monitor, keyboard, and mouse to the NG Firewall hardware and power it on. The hardware should take a few moments to boot up, start the NG Firewall software, and launch the Setup Wizard.
During the Setup Wizard, you will log into your ETM Dashboard account. Once logged in, you will provide some details about the device and can apply your subscription to the device. Once your device is associated to your ETM Dashboard account, you should be able to access it remotely from the Appliances tab in the blue bar at the top of the screen. Click the appliance in question to go to its specific page, then click the Remote Access button.
After all of this is connected, you may be wondering about specific requirements if you are a business or school. Here are links to some of our compliance articles: